![](/static/253f0d9b/assets/icons/icon-96x96.png)
![](https://lemmy.world/pictrs/image/e4083c7c-83c3-4258-8370-708e95e309b3.png)
Sweet thank you!
Sweet thank you!
How’s Freecad these days? I avoided awhile ago it because it looked difficult to use but I think this might push me over to it
I have a Espon ET-5150. Its worked fine so far but I wish my wife would’ve let me spring for a laser printer.
Thank you for the tip! I’ll look into those for sure. It sounds like they would be a perfect fit with very little downside
Hahaha I’m good there! I’m on month 2 of what should’ve been a 3 day project for a friend. I’m chalking it up to a bad model after this and moving on to a different print to save my sanity
Thank you! I gave it a clean and fingers crossed it works put tomorrow when I’ve got some more time to mess with a test print
Thank you! Unfortunately i didnt get a cool spaghetti monster this time, but I like the idea of keeping them to see how far youve come
Thank you! I that makes me feel better about leaving it print while I’m at work
Thank you! I’d rather deal with a contaminated print than a fire
That’s fair. More accurately a different reputable brand. Prusa and Bamboo Labs are both ones I would look at if I had to do it all over again.
Good to know. I’ll add that to a check list to go through every now and again
Ah man, but at least you have 2 years of experience under your belt!
Thank you, that did the trick to remove it!
If i were to leave something like that, is there a risk of a fire starting?
Thank you for your advice and encouragement! Its comforting to know that its happened to everyone and its a common error.
After everything is cleaned up should i reseat the heat block before i remove the nozzle to clear the gunk or after?
Anytime. Thank you for your words of encouragement!
No worries! Thats exactly where it is. The burned on stuff goes all the way down the side and around the back.
I’m afraid this bing need to be totally taken apart but i haven’t done much more than investigate and pull at some easy pieces so far.
Keep in mind this is my first printer and I’m new to the hobby so I’m at the why isn’t this working and why did I do this to myself stage. This might not be a problem for more experienced people. Thankfully this community exists because I’d be lost otherwise
The problem is I don’t even know what happened or how the pla got around that silicon sleeve. Part of me just wants to say forget it and continue to print with it like this but I feel like this is just a fire waiting to happen.
Thank you for the advice! I think I’m gonna run with it and put the printer in the closet for a bit.
Anything else but an Ender 3. I’ve spent more time tinkering with the thing than I have printing
Yes, I just finished printing a rudder core for my sailboat.
For all the headache its caused, its also saved me from several trips to the store to find cable ties, chip clips, a hair dryer holder, pencil cups, spice racks, etc.