Hi there!
I’m looking into getting myself a good printer and I am wondering if I need to install some platform-specific drivers for them to run. I am running Debian 12 (GNU/Linux) and I am afraid that I must run some proprietary blob to connect to the printer.
Could someone share their experience please? Even if you don’t use Linux, your feedback would be very appreciated!
(Also, while you are at it, please share some recommendations for printers, I don’t really know where to go (>v<) Have about ±500€ )
I have a Sovol SV06, which normally uses an SD Card but I flashed Klipper on it and connected a Rasperry Pi to it (which is connected to my network via ethernet) and now I also have a web interface and can just upload the files and start the print from there.
Since it’s using the Raspberry Pi instead of the built-in microcontroller for all the calculations, it’s also a lot more accurate.