That’s pressure.
Pushing down on me.
Pressing down on you.
no man ask for.
Under pressure that burns a building down
Splits a family in two
puts people on streets
Welcome to engineering, where we have MPa as a unit of stress and mm/mm as a unit of strain!
mm/mm?? why not call it m/m?
Because we’re precise!
Because practicality. Strain generally occurs across mm scales at most for most traditional tensile tests and relevant materials. Normally it’s actually much less than mm. Occasionally you see micrometers/micrometers.
How is it more practical when 1 m/m = 1 mm/mm = 1 μm/μm?
Because excel doesn’t have built in unit handling so when you enter in readings from the strain gauge you’ll probably enter them in what’s being reported.
You can write the units of strain however you like, I often say ul for unitless.
The original specimens and data are usually in mm, not meters so mm/mm makes more sense than m/m, although you do have a point
Why km/h (or mph) and not ft/year? Because the numbers have a nicer magnitude then.
Doesn’t apply here, say for example i have a piece of steel with length 100mm and it stretches 10mm, is mm/mm the strain would be 0.1 mm/mm, in meters it would be 0.1m/m
Really strain is dimensionless but occasionally people add units
I feel like I should’ve spotted that… they’re the same units. 🤦
I was told that you also sometimes have four basis vectors in 3D
Agreed. Perhaps it was based on tensile stress? Tensile stress = deforming force / cross-sectional area
Yes. Stress is a measure of an object’s internal pressure.
So what you are saying is, I have to eat more, get fatter, widen my area and therefore reduce the stress?
Got it.
That will just increase the force (gravity).
You need to lie down. That increases area but not force.
This is amazing and really deserves more updoots
Latex math mode text without
\text{}Pathetic
