• Catoblepas@lemmy.blahaj.zone
    link
    fedilink
    English
    arrow-up
    97
    arrow-down
    3
    ·
    8 months ago

    The best suggested explanation IMO is that it’s a way for blacksmiths to demonstrate their skill.

    “lol stupid scientists don’t know what knitting is” I would file under “actively anti-intellectual”.

    • Tar_Alcaran@sh.itjust.works
      link
      fedilink
      English
      arrow-up
      19
      ·
      8 months ago

      Kinda like the little nib on top of old saw blades. It doesn’t really do anything, but if they can make that complex little nib, then they can probably make pretty decent sawblades too.

      • Poppenlockenheimmer@lemm.ee
        link
        fedilink
        English
        arrow-up
        8
        ·
        8 months ago

        I’ve always heard that the nib was meant to help you gauge when to stop your pull stroke and start your push stroke so that you use the whole saw and don’t wear the teeth unevenly. Is this not the case?

          • Blue_Morpho@lemmy.world
            link
            fedilink
            English
            arrow-up
            2
            ·
            8 months ago

            Google says it’s a vestigial ornament to represent a handle from when steel quality was poor.

            That is all saws used to have two handles because of poor steel quality. The nib was where the front handle would attach. Later the front handle wasn’t needed but the nib remained and was later shrunk.

            A toolmaker could put a nib and still have bad quality teeth. Doesn’t seem like you would judge quality by the nib.

    • someguy3@lemmy.ca
      link
      fedilink
      English
      arrow-up
      4
      arrow-down
      1
      ·
      8 months ago

      Iirc it was only found in northern areas. Can’t see demonstrations of skill being only there.