Indeed, the article was written with Backblaze B2 as the S3-compatible storage used.

Requires an iPhone 15 Pro or an iPad

Having a 3d printer is super convenient for any home or shop repairs I need to make. I have so many curtain spacers and custom hooks all over the place now. The key is to get some hours in Fusion or some other good CAD software so you can whip up custom parts in minutes. You may get it wrong the first few times, but a couple minutes of tweaks and then you have a new part printing while you go back to working on other stuff.

The Swedish Maker just put out a video about how transformative 3d printing has been for his workflow. https://youtu.be/p2bClWmKHRM

Not a lawyer, but there are lots of intricacies to this. You can own a trademark without having it be a registered trademark. Registration is expensive and then you are expected to actively defend use of your trademark. Be prepared to pay lawyers to send cease-and-desist letters to parties using your trademark for financial profit. Not to mention you have to be/become a business engaging in interstate commerce using this trademark.

https://www.uspto.gov/trademarks/basics/what-trademark

https://www.uspto.gov/trademarks/basics/how-much-does-it-cost

dedsec doesn’t appear to be a registered trademark in the US at this time.

https://tmsearch.uspto.gov/search/search-results

edit: added the word registered

Do you have an auxiliary power connector hooked up to the HBA? Here is the manual.

Awesome project!

Does Sonic serve drinks in plastic cups now? It has been a while since I’ve been to any of them in WA.

Can confirm. My cats request this jam be played to them on the daily.

Time is relative, Carter can tell you about it.

Scholastic announced Thursday that “Sunrise on the Reaping,” the fifth volume of Collins’ blockbuster dystopian series, will be published March 18, 2025. The new book begins with the reaping of the Fiftieth Hunger Games, set 24 years before the original “Hunger Games” novel, which came out in 2008, and 40 years after Collins’ most recent book, “The Ballad of Songbirds and Snakes.”

or whales?

It stopped around 100m to identify a safe landing spot according to this article.

https://spacenews.com/change-6-lands-on-far-side-of-the-moon-to-collect-unique-lunar-samples/

I buy samples from Atomic Filament when I don’t know which filament would work best for a project. They are 50g spools for under $4 each. It is usually enough filament to print out a filament sample card and a small test piece.

Molex MicroFit 3.0 are my gold standard for general purpose low voltage connectors. I buy from an electronics distributor (Digikey or Mouser) and crimp my own connectors. However, I did find a listing on Amazon for pre-crimped jumper wires and connector housings.

https://a.co/d/hrrtj3f

I highly recommend checking with local vets rather than an animal hospital if your pet has time. Our vet extended my cat’s life multiple times over the years for a fraction of the price. Kidney/bladder surgery for stone removal was less than $1k including a week of room and board. Hands down, the best money I’ve ever spent.

Use an x-acto knife or a $5 PTFE cutter for best results.

Amazing how that Saturday I set aside to build a Voron2 turned into a weeklong adventure. Then the mods, troubleshooting of mods, ERCF, and building of a Trident consumed so much more time. I guess that is just Voron Life.

I would never use a printer without z-tilt adjust as well. The bed is trammed using motors automatically and then the bed mesh just accounts for surface flatness.

Snapraid to a single drive works well if you are fine with daily snapshots of up to 6 drives.