I just woke up and read “Hawai’i gets $9” and stopped very confused for a moment.

Wow, this is an incredible guide thanks for showing me

I figured there might be something like this that i hadn’t seen. I’ll look into it tomorrow, i get the feeling this would cause the inconsistency.

I have never bought an ender. I just happen to have one :P

Ah, thank you for the advice and the link!

The falling prints i think have issues in the same spots, there are relatively small patches around the print surface that don’t print very well, though they don’t seem to correspond to the bed leveling screws or anything. Now that i say that I’ll have to check that I’m using the mesh level correctly when i get home.

I’m still using a Bowden type extruder. The extruder itself is a generic aluminum one. My filament is run out of a sunlu dryer by the side of the machine.

I think i actually raised the jerk at one point to reduce the radius on corners, so i can bring that back down again and experiment with acceleration.

I have a glass bed and I’m using the tramming function with the mriscoc firmware to give me depth readings for each of the four screws, and I usually reign them in to about 0.04mm range. Parts close to each other tend to have similar but not the same results, and i think the patches are too small to be from bed leveling, usually only a couple centimeters.

I can redo esteps, i can see what you mean about the overextrusion. I only set my esteps to the number recommended by the manufacturer of my extruder, but i haven’t measured it myself yet, maybe that’s a bit silly of me. Though if that’s the problem then I’m still curious why it’s different in different areas.

I can check out acceleration too, i looked up what acceleration and jerk meant at one point but it didn’t make much sense to me at the time.

Common piracy W

If only i knew the truths 😞

They rounded it on the wrong axis

That would be very dumb because methane leaves the atmosphere on its own much more quickly than CO2. Roughly 12 years compared to carbon dioxide being closer to 500 years.

Of course it’s kind of a half life so putting a single number on it isn’t perfect but that’s the difference in scale at least.

I may have found a phone for you. It’s called the unihertz tank 2

• 12gb ram
• 256GB memory (expandable)
• 15500 mah battery
• 60W charging
• 120hz display

https://www.unihertz.com/products/tank-2

Comes with a few other really interesting features you don’t see on any other phone (like a goddamn laser projector?), though i think the processor is a little underpowered.

I wish thicker bezels were more common tbh. It’s annoying to swipe from the side of the screen when my case is in the way.

i don’t think they like the android community much since a lot of the community is dedicated toward getting away from the surveillance and theft that Google profits from.

Unihertz is awesome. I wish there was a phone like the jelly star but non-tiny as i like big screens.

What are we being distracted from, exactly?

I feel more lifted up than i did before, so it worked for me. Ngl though, hearing the DEA going away for good would be much more uplifting.

deleted by creator

It was one sentence. How did you manage to misunderstand it?

Hey, don’t let good be the enemy of better. A billionaire advertising taxes like a good thing is better than anything I’ve ever seen Elon musk do.