Razer mice and keyboards can be managed with openrazer under Linux. I still use deathadders on a few Linux machines ( and one Windows games PC ) but I’ve ditched my razer keyboards for keychron which don’t really need any software. You can configure the RGB components of them all with openrgb if you want in Linux and Windows.

I replaced mythtv with tvheadend on the backend and kodi on the frontend like 5 or 6 years ago.

The setup and configuration at the time on mythtv was slanted towards old ( obsolete ) analog tuners and static setup and tvheadend was like a breath of fresh air in comparison where you could point it at a DVB mux or two and it would mostly do what you want without having to fight it.

I’m not sure how much longer I’ll want something that can tune DVB-S2 and DVB-T though. Jellyfin and friends handle everything other than legacy TV better than kodi these days.

The most impressed I’ve been with hardware encoding and decoding is with the built in graphics on my little NUC.

I’m using a NUC10i5FNH which was only barely able to transcode one vaguely decent bitrate stream in software. It looked like passing the hardware transcoding through to a VM was too messy for me so I decided to reinstall linux straight on the hardware.

The hardware encoding and decoding performance was absolutely amazing. I must have opened up about 20 jellyfin windows that were transcoding before I gave up trying and called it good enough. I only really need about 4 maximum.

The graphics on the 10th generation NUC’s is the same sort of thing that is on the 9th gen and 10th gen desktop cpu’s, so if you have and intel cpu with onboard graphics give it a try.

It’s way less trouble than the last time I built a similar setup with NVidia. I haven’t tried a Radeon card yet, but the jellyfin docs are a bit more negative about AMD.

I swear allegiance to the only one true storage vendor, Micropolis. The Micropolis 1323A being the embodiment of perfection in storage basked in the glow of the only holy storage interconnect, MFM.

I wait patiently for the return of Micropolis so that I may serve as their humble servant.

Your bridge isn’t bridging properly. If Router B is sending a destination unreachable then the packets are being handled on it further up the stack at layer 3 by some sort of routing component rather than by a layer 2 bridging one.

Often on Linux group membership changes only take effect on login. So you could try logging out of your session and logging back in after your group changes to test that theory out.