Oh, I agree, resin prints are much more detailed. I just wanted to provide another point of reference for FDM mini prints, since the parent commenter’s FDM prints looked… rough.

What nozzle and layer height were you printing with? I’ve printed a few minis with a 0.2mm nozzle and 0.08mm layer height and the results look much smoother than what you had…

I’ve got some Barrina T5 1ft grow lights that everybody on IKEA Greenhouse Club recommends. I checked the PPFD with Photone, directly under the centre of the light strip: 72.9 at 20cm away, 47.5 at 30cm away, 34.8 at 35cm away. They’ve served me very well; I’ve got plants in a living room that get very little natural light but with these lights they’ve been thriving!

For other plants, I’ve got some GE grow light bulbs. These ones I’ve screwed into table lamps for my smaller plants. For these bulbs, the PPFD measurements I got were 300 at 10cm away 100 at 20cm away (directly under the bulb).

I’ve printed a few minis but have no idea where to start in regards to painting them - got any good resources to share?

Yep, same. Mine corroded after a few months. Haven’t tried the epoxy idea from the comments but it sounds promising…

I think it’s a Sansevieria zeylanica or something similar!