Wow, thanks!! That actually solved it apparently! Why does the wireguard config change if i can ping outside the docker container though? Is it because the wireguard client inside the container opens up ip adresses or something? :) Thanks again! Itried to find a solution for many hours yesterday :D

Oh and is the ‘,’ in the allowed ips meant as an “and” or rather an “or”?

When I am on the server, it can even ping the domain. On my laptop, it can only resolve the domain to the correct ip

Changing the domain does not change the problem sadly. I thought .local is a safe one to use

So in the dnsmasq.config file is this entry: ‘address=/server.local/192.168.178.10’ and using nslookup it resolves it correctly

I agree with the sugfeations to clean your bed. But i never had to use glue, I just releveld the bed or redid my first layer calibration

Never needed to

C ube?

I have read the same, but also read it is not very true anymore, specially with dedicated server drives. I would not worried too much about it honestly

I thought birds have a little bit of iron enrichment above their beaks, wich tells them the direction?

What would you use to RAID the drives? Die you try zfs for a USB das?

Thanks! I took a look at tailscale a while back but was turned off immediately because it requires an account at their site. Would headscale run on my own server at home?

But isnt tailscale not just a wrapper for wire guard that does not require big configuration? So I would still end up an VPN and send all my traffic over my home network?

So… that’s why I never tidy up my room. I’m just too smart!

The only correct way of collaboration and sharing code.

Can not recommend. The levels were very difficult but short and the final reward was shit

I think they are pretty funny. They don’t matter, it’s just a nice little colorful image that has to be there. There is no information transported or displayed incorrectly, because there is none 😄

I am sorry for that experience.

Thanks! That seems rather easy. Only thing I’m not sure about, I have basically only access to the pi over SSH. I could use a screen and keyboard but would prefer not to. What would happen if I configure the network wrong on the pi and can not connect anymore, even over my home network? Could I change the config by putting the SD card into my laptop and changing a file? Or is it possible to make it redundant, so if it can’t find a DHCP server, it automatically switches to the preconfigured settings you described? :) Thanks a lot

I mean if you consent, they can do it. Maybe you can opt out like with meta. I think the issue will be, that ai can reveal secrets it is not supposed to

I have 2 HDDs with a speed of 180mb/s with a burst of 6gb/s according to the Seagate website. Usb3.0 has a data transfer rate of 5gbit/s

So the usb connection will be the bottle neck, but 1. My network speed is not that fast and 2. 5gbit/s is still plenty I think?