Update: I wasn’t able to fiddle with it for a few days but after getting back to it have something I like.

My current settings are based on the feedback in this thread and:

• https://all3dp.com/2/ender-3-s1-cura-profile-settings/
• https://www.thingiverse.com/thing:5191593

z-offset made the single biggest difference. I reset the printer config and re-leveled.

For this filament: https://www.amazon.com/Inland-1-75mm-White-Printer-Filament/dp/B084RDMG7C/

Global Settings
Layer Height		0.20
Initial Layer H...	0.20
Wall Thickness		0.80
Top/Bottom T...		0.80
Combing Mode		infill
Build Plate Adh...	brim

Extruder
Wall Line Count		3
Print Thin Walls	True
Travel Speed		110
Initial Layer Sp...	20
Retraction Dist...	0.8
Retraction Speed	45
Minimum Extru...	1
Brim Width		4

Filament Print Settings:
Default Printing Temperature	210
Default Build Plate Temperature	 60
Standby Temperature		195
Fan Speed			100

I printed a tower a few days ago and it looks good anywhere from 200 to 215. I’m going to keep trying though.

z offset / nozzle height seems to be the thing. I’ve raised it up and it looks better. After that I played with the temp a bit and it seems to be happier around 210-215 though there is more stringing.

So far, all attempts at ironing have been a disaster, both zig zag and concentric. I’m going to continue dialing in the z offset and temp before ironing.

Weird. I couldn’t post the original pic but a screenshot of it seems to work.

The spool doesn’t say “silk” but the sticker does say print temp 215-230: https://www.amazon.com/Inland-1-75mm-White-Printer-Filament/dp/B084RDMG7C/ I’ll give that a shot & see if it looks any better.