Same here in New Zealand. Had them around for a while but never heard about flexible prices like this (other than items on sale of course)

Like many others on here, my stock is now 0.6mm

I’ve also tried a 0.8mm which is amazing haha. Though it definitely has it’s limitations, so I usually just stick with 0.6mm

Oh yes! haha I often do the same with the 1mm type prints :)

Yeah, I’ve always been meaning to get that process tightened down Abit to minimize the number of iterations required. Though I haven’t figured out what that would entail lol.

Cool! Will do :)

I’ve always been meaning to try the photo thing - I’ve always just reverted to making some sketches on an ipad/paper, and taking as many measurements as I can, and then printing some test fits.

That’s good to hear!

Might be the push I needed to give it a go :)

Cool!

I’ve been wanting to do something like this for a while, but was always worried about the water. I was thinking of getting some epoxy resin and coating it.

Haven’t done any printing in PLA (Only PETG and TPU) but is there a chance it’s due to your filament being too wet?

This. Checkout the Klipper documentation at https://www.klipper3d.org/Probe_Calibrate.html#calibrating-probe-z-offset