Looks like nice even pressure, good job! It looks like you’re underextruding a bit though
Looks like nice even pressure, good job! It looks like you’re underextruding a bit though
Same, popped up while in the middle of Satisfactory
And they sweat milk!
It may try to connect to open wifi networks instead, maybe
Guessing it’s the Litter Robot? We’ve got one as well. Our youngest cat constantly tries to play in it while it’s doing a cycle
Yeah, this isn’t uplifting at all. It’s just sad
Fun fact! Glue is put into the cheese on pizza slices for promotional purposes. It’s what gets them that nice stringing stretching cheese on video.
Got any peer reviewed scientific evidence for your positions?
Trying to surpass Endwalker would be a feat. How do you go above flying to the edge of existence and destroying the concept of nihilism? Dawntrail wasn’t as grandiose in its story, but overall it was FUN, which is the important part to me. I read an article ago saying this was a better Stormblood which I’d agree with.
I always read it as Law Enforcement Officer
It was definitely smoother this time around. SE had an easier time for sure, since they didn’t need to stop people buying it like during Endwalker
With Sunlu’s new filament joiner coming out, I might give this a try by splicing segments of different browns together into a big roll. It’s a very near concept, and your print looks amazing!
The following was added to my fstab
//192.168.86.181/TrixieTV /home/brobot/Storage/Completed/TV cifs credentials=/home/brobot/.smb 0 0 //192.168.86.181/TrixieMovies /home/brobot/Storage/Completed/Movies cifs credentials=/home/brobot/.smb 0 0
The credentials are using a new user ‘moose’ that owns the folders and has full control
user=moose password=3141
I’ll look into that, thanks!
We just had a total power outage, and restarting my main machine I remembered I have Linux Mint installed as duel boot. I’ve been waiting for a final push to get me to migrate away from Windows. Would it be easier to do all this from Linux Mint instead of Windows?
No GUI on my end (It’s been fun learning to use a headless server). I have to sudo to be able to do anything in the mount locations. Using ls -s, the permissions and owner aren’t changing after using chown and chmod.
Yup, the mount is authenticated and the Share Permissions on Windows have it set to Full Control for Everyone, plus ‘Password protected sharing’ is turned off under Advanced Network Settings.
For calibrating your printer, I always recommend https://teachingtechyt.github.io/calibration.html. Everything is step-by-step and helps teach you about the calibrations and what different settings do. I agree with the other commenter that you’re underextruding, based on your layers not filling in. Getting your E-steps calibrated is extremely important, then I’d start working on flow rates (which can change between rolls and brands)
IT can have scripts and flowcharts they are required to follow, even if it is redundant to tech savvy people.
That’d be your carrier being bad, not the Pixel. You could be right next to the tower, but depending on congestion and your plan you could be limited. You’re driving a car that can go fast, but getting stuck in traffic.
I love Elegoo’s printers. Got a Neptune 2S and a 3 Pro tuned and running Klipper, they’re good workhorses