KryptonBlur

If you want a whole kit then the AirGradient ones look pretty nice

Ploopy have given trackball enthusiasts a lot more choice at least!

This is such an awesome project!

No worries at all! Glad it’s all sorted!

Have all these prints been sliced at the same time? (Like on the same version of the slicer)

I had an issue on my filament printer where I thought it was messing up, so I tried a few different prints to make sure and it was still failing. But it turned out that it was caused by a buggy Cura update

Filled it in, good luck with your thesis!

I hadn’t tried them until I went to one of their shops last year to try them on. I didn’t really expect to like them, but wanted to give it a go and was pleasantly surprised. They are now my favourite, most comfortable shoes (although sometimes I wish they had a slightly thicker sole). It is worth noting that the insole they come with didn’t last very well though (it started to crumple up in the shoe and became uncomfortable) so I replaced it with a cheap regular insole I found online and it made them even more comfortable (a bit more cushioning but still a wide toe box and flexible shoe).

I’ve been enjoying my Vivo barefoot shoes. But obviously they’re only really good if you like having a thin sole on the shoe. They have a repair service though so that’s one of the reasons I recommend them.

N-O-D-E.net was really good but there’s not been much on there recently (but still worth reading through if you’ve not come across it)

Yeah definitely a project worth keeping an eye on, and I think they’re always looking for volunteers and collaborators

Also Amybo.org are doing open source protein fermentation.