Back when I was even less experienced in self-hosting I setup my media/backup server using a RAIDZ1 array and 3 x 8TB disks. It’s been running well for a while and I haven’t had any problems and no disk errors.

But today I read a post about ‘pool design rules’ stating that RAIDZ1 configurations should not have drives over 1TB because the chances of errors occurring during re-silvering are high. I wish I had known this sooner.

What can I do about this? I send ZFS snapshots to 2 single large (18TB) hardrives for cold backups, so I have the capacity to do a migration to a new pool layout. But which layout? The same article I referenced above says to not use RAIDZ2 or RAIDZ3 with any less than 6 drives…I don’t want to buy 3 more drives. Do I buy an additional 8TB drive (for a total of 4 x 8TB) and stripe across two sets of mirrors? Does that make any sense?

Thank you!

  • Decronym@lemmy.decronym.xyzBEnglish
    2·
    7 months ago

    Acronyms, initialisms, abbreviations, contractions, and other phrases which expand to something larger, that I’ve seen in this thread:

    Fewer Letters More Letters
    RAID Redundant Array of Independent Disks for mass storage
    SATA Serial AT Attachment interface for mass storage
    ZFS Solaris/Linux filesystem focusing on data integrity

    3 acronyms in this thread; the most compressed thread commented on today has 30 acronyms.

    [Thread #630 for this sub, first seen 26th Mar 2024, 18:55] [FAQ] [Full list] [Contact] [Source code]